Check_snmp_int.pl

[Mike Koponick]

I'm using check_snmp_int.pl to check on interfaces on switches/routers,
but can't seem to have it look at a single interface. I think this is a
"/" issue, but am not sure.

 

When use the command:

 

./check_snmp_int -H 10.xx.xx.xx -C <community> -n GigabitEthernet0/1

 

I receive the following:

 

GigabitEthernet0/1:UP, GigabitEthernet0/12:DOWN, GigabitEthernet0/10:UP,
GigabitEthernet0/11:DOWN: 2 int NOK : CRITICA

 

I only wish to see one interface, rather than all of them as some are
not in use and *should* be down.

 

Thoughts? Maybe it's time for more coffee?

 

Thanks!

 

Mike

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://www.monitoring-lists.org/archive/users/attachments/20060216/586525c9/attachment.html>